Filter
Top Products
5
GB
The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.
The Control panel lock and DEMO mode can be
activated/deactivated even when the control panel is
switched off.
Control panel lock
To lock the oven controls, press the and
buttons for 5 seconds. A buzzer sounds and the
TEMPERATURE display shows r-0.
Press again to unlock the controls. The STOP button
is always active.
Demo mode
The oven can operate in DEMO mode: all heating
elements are deactivated, and controls remain
operative.
To activate the DEMO mode, press the
, , and
buttons simultaneously.
To deactivate the DEMO mode, press the
, ,
and buttons at the same time. A buzzer sounds
and the display shows demo off.
Setting the clock and timer
After the appliance has been connected to the mains, or
after a blackout, the
button will begin to blink.
To set the time:
1. Set the hour figure within 8 seconds using the +
and - buttons on the right hand side.
2. Press the
button again.
3. Adjust the minutes using the + and - buttons on
the right hand side.
4. Wait at least 8 seconds for the setting to be
memorised, or press the
button again.
To make any necessary changes, switch on the control
panel by pressing the
button, then press the
button and follow the described procedure.
When the set time has elapsed, a buzzer will sound.
The buzzer will automatically stop after 6 seconds or when
any active symbol on the control panel is pressed.
To set the timer, press button
and repeat the steps
described to set the clock. The
button indicates that
the timer is active.
The timer does not switch the oven on or off.
Starting the oven
1. Switch the control panel on by pressing the
button.
2. Press the button corresponding to the desired
cooking mode. The displays show the time and
temperature of the selected cooking mode.
3. Press the START button to begin cooking.
4. The oven will begin its preheating phase, and the
current preheating temperature indicator lights turn red.
The temperature may be changed by pressing the +
and - buttons on the right hand side of the control
panel.
5. When the preheating stage is complete, a buzzer
sounds and all current preheating temperature indicator
lights are illuminated: place the food in the oven.
6. During cooking it is always possible to:
- Change the temperature by pressing the + and -
buttons on the right hand side of the control panel.
- Set the cooking duration (see Cooking Modes).
- Press STOP to interrupt cooking.
7. The oven switches off automatically after two hours:
this default time is set for all cooking modes for safety
reasons.
The cooking duration may be changed (see Cooking
Modes).
8. If a blackout occurs, while the oven was already
operating, an automatic system within the appliance
will reactivate the cooking mode from where it was
interrupted as long as the temperature has not
dropped below a certain level. Programmed cooking
modes which have not started will not be restored and
must be reprogrammed.
There is no preheating stage for the BARBECUE
mode.
Never put objects directly on the bottom of the oven;
this will avoid the enamel coating being damaged.
Always place cookware on the rack(s) provided.
Cooling ventilation
In order to cool down the external temperature of the
oven, a cooling fan generates a stream of air which
escapes between the oven control panel and the oven
door. At the beginning of the FAST CLEAN mode, the
cooling fan operates at low speed.
Once the cooking has been completed, the cooling
fan continues to operate until the oven has cooled
down sufficiently.
Oven light
When the oven is not in operation, the lamp can be
switched on at any time by opening the oven door.
Start-up and use