Filter
Top Products
12
GB
Maintenance and care
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
The stainless-steel or enamel-coated external parts as
well as the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water and
neutral soap. If these stains are difficult to remove, use
only specialised products. After cleaning, rinse and dry
thoroughly. Do not use abrasive powders or corrosive
substances.
Ideally, the inside of the oven should be cleaned after
each use, when it is still lukewarm. Use hot water and
detergent, rinse and dry with a soft cloth. Do not use
abrasive products.
All accessories - with the exception of the sliding racks
- can be washed like everyday crockery, and are even
dishwasher safe.
Never use steam cleaners or pressure cleaners on the
appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with
a soft cloth. Do not use rough abrasive material or sharp
metal scrapers as these could scratch the surface and
cause the glass to crack.
To clean more thoroughly, you can remove the oven door.
1. Open the oven door fully (see diagram).
2. Lift up and turn the small levers located on the two
hinges (see diagram).
3. Grip the door on the two
external sides and close it
approximately half way. Unlock
the door by pressing on the
clamps F, then pull the door
towards you lifting it out of its
seat (see diagram).
To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven periodically. If the
seals are damaged, please contact your nearest After-
sales Service Centre (see Assistance). We recommend
not using the oven until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
Wattage 25 W, cap
E 14.
3. Replace the
glass cover (see
diagram).
Sliding Rack Kit Assembly
To assemble the sliding racks:
1. Remove the two
frames, lifting them away
from the spacers A (see
figure).
2. Choose which shelf to
use with the sliding rack.
Paying attention to the
direction in which the
sliding rack is to be
extracted, position joint B
and then joint C on the
frame.
3. Secure the two frames
with the guide rails using
the holes provided on the
oven walls (see diagram).
The holes for the left
frame are situated at the
top, while the holes for the
right frame are at the
bottom.
4. Finally, fit the frames on spacer A.
Do not place the sliding racks in position 5.
F
F
A
D
B
C
Left
guide rail
Right guide
rail
Direction
of extraction