Filter
Top Products
16
The electrical connection to the mains must be made on
the appliance. The power voltage and frequency are as
indicated on the rating plate.
! THIS APPLIANCE MUST BE EARTHED.
Connecting the power supply cable
To open the terminal board:
• Using a screwdriver, press on the tabs situated on each
side of the terminal board cover.
• Pull open the terminal board cover.
To connect the power supply cable, proceed as follows:
• Unscrew the cable clamp screw and the contact screws
L-N-6.
• Fasten the wires beneath the screwheads using the
following colour scheme: Blue (N) Brown (L) Yellow-Green
6
• Fasten the power supply cable in the corresponding cable
clamp and close the cover.
Electrical Connection:
Voltage Frequency: 230 V-1+N 50Hz
Fuse Section: 16A
Supply cable: 3x1.5mm2
You can connect your oven to the system means of a
terminal board. Refer to above information for the minimal
cable sections and the calibration of the protective
elements according to the connection.
If the appliance is installed with a junction box, an omnipolar
circuit breaker - with a minimum contact opening of 3mm
- should be installed between the appliance and the mains.
Power cable supply connection to the electrical mains:
We recommend you use a power supply cable which is
long enough to allow you to take the oven out of its recess
in the event of maintenance operations (only use HAR - H
05 - RRF quality cables fitted with a plug conforming to
the regulations in force.
The plug must be accessible at all times.
Unplug the appliance before all operations, even when
replacing the oven lamp.
Using the appliance without correct earthing is highly
dangerous.
! After connecting the appliance to the flexible cable,
tighten all the screws on the terminal board.
4 2
N L
Electrical connection