Hotpoint ULTIMA Dishwasher User Manual


  Open as PDF
of 20
 
GB
7
•Iffittinganundersinkwaste
disposal unit, cut out the membrane,
bung or blanking plug.
Ensure the drain hose is securely attached, to prevent it
coming away while the machine is in use and causing a flood.
Fit hose to waste securely using a “Jubilee” type clip.
Anti-flooding protection*
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the water supply
in the event of anomalies or leaks from inside the appliance.
Some models are also equipped with the supplementary safety
device New Acqua Stop*, which guarantees anti-flooding
protection even in the event of a supply hose rupture.
WARNING: HAZARDOUS VOLTAGE!
Undernocircumstanceshouldthewaterinlethosebecutasit
contains live electrical parts.
TheCompanyshallnotbeheldresponsibleforanyincidents
that occur if these regulations are not observed
Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack, if any.
Immediately before running the first wash cycle, completely fill
the salt dispenser with water and add only then approximately
1kgofsalt(
seechapterRinse-aidandrefinedsalt
). The water
may overflow: this is normal and is not a cause for concern.
Select the water hardness value (
seechapterRinse-aidand
refined salt
). After the salt has been poured into the machine,
theLOWSALTindicatorlight* switches off.
If the salt dispenser is not filled, the water softener and the
heating element may get damaged as a result.
The control panel features a “Touch Control” system*;
press the symbols lightly with your fingertips to activate
the command.
The machine has a buzzer/set of tones
(depending on the
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
light
(depending on the dishwasher model)
.
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
Switching the appliance on for the first time
Selecting the language
SwitchonthemachineusingtheON/OFFbuttonandselectthe
desired language using the buttons next to the grey arrows
(the
default language is English.)
PresstheOKbuttontoconfirmtheselection.
PresstheESCbuttontoexitorwaitafewseconds.
SETTINGS button
This button makes it possible to select:
logodisplay,volumeofbuzzer/setoftones,language
selection, rinse aid adjustment, water hardness adjustment,
control panel lock.
Child safety lock
The control panel lock can be activated when the
dishwasher is switched on or when a cycle is in progress using
the “Lock” button. Press again to deactivate the function.
UsetheSETTINGSbuttontoaccessthemenu.Thecontrol
panellockcanbeactivatedautomaticallyafter10/30seconds
from the cycle start.
 previous next