Filter
Top Products
EXISTING FAN
B11
E
B12
Existing Construction
B13
2
1
B14
Route wires through the strain relief. For supply connection,
use wires suitable for at least 90˚ C (194˚ F).
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new motor
housing (7.25” x 7.75”).
Move the housing into position above the ceiling.
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
E
B15
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
8
41940-01 1/11/2006