Filter
Top Products
EXISTING FAN
D11
F
D12
15
Existing Construction – accessible only from below
D13
2
1
D14
Route wires through strain relief.
Remove an existing fan and check to make sure the open-
ing is large enough to accommodate the new motor hous-
ing (8”x 8 1/2”).
Move the housing into position above the ceiling
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
F
D15
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
41941-01 3/29/2006 41941-01 3/29/2006
05-HF-012-EngS_3.29.06.indd 15 3/29/06 3:19:35 PM