Filter
Top Products
IGFC-CR3H-HTB-1104
6
dust, grease, oil, and fingerprints without the need for
cleaning fluids. A light spray of the cleaning fluids listed
above will reduce the time required for cleaning. These
materials have been tested and proven to clean the non
glare glass without scratching or damaging the Anti-
reflective coating.
Cleaning solvents - for more difficult cleaning jobs,
these products are recommended for the cleaning of
glass. Care must be taken where they are used. The
solvents are tested for use on the outside of the glass.
No solvent should be applied directly to food product
and food should be protected from overspray unless
they carry the USDA-A1 ranking.
The food should be covered or the solution should be
sprayed on a cleaning cloth away from the case if it is to
be used inside the case with product present.
The following products will not damage the non-glare
coating on the glass:
• Windex
®
• Glass-Plus
®
• Exceed™ Multi Surface Glass Cleaner - from Kay
Chemical Company, Greensboro, NC
• Warm water
Under no circumstances should the following be used
for cleaning glass:
• Coarse paper towels
• Souring Pads or Powders
• Steel wool or steel fiber materials
• Blades
• Acidic or highly Alkaline detergents
• Fluorine based detergents
Lift-up Glass Maintenance
At Installation and after replacement:
The top cylinders, which allow the raising and lowering
of the glass, have been carefully tested for proper
tension. However, during shipment, the lubricant inside
may have settled. This settling may cause excessive or
uneven tension on the glass - to the point of breakage.
Before opening the glass for the first time and after
installing new cylinders, it is advisable to perform these
three easy steps before completely raising the front
glass.
1. Slowly raise and lower each glass section 6 times, to
a height of 6".
2. Increase the height to 12", and raise and lower the
glass 6 more times.
3. Finally, raise the glass to it's full extension. This
should release any settled lubricant in the cylinders,
and prevent any stress on the front glass.
After the case is brought to operating temperature the
first time, recheck the Allen screws on the glass
once the case once the case is in full operation
and brought to temperature.
Temperature changes can affect the size and shape of
the materials involved, and can cause changes in the
secure fit of the glass and the clamp.
Cylinders are a wear item.
They are designed:
•To support the glass
when fully open
• to allow the glass to
close slowly
Have your Service
Contractor replace the
cylinders when required.
CAUTION
Glass is heavy and
can cause bodily
damage. Check
support cylinders
for periodic
maintenance
Periodic Inspection and Maintenance
Piston cylinders are a wear item. They are designed to
support the glass when fully open and to allow the glass
to close slowly. Glass is heavy and can cause bodily
damage.
Check support cylinders as a part of periodic mainte-
nance. Have your Service Contractor replace the
cylinders if they show signs of weakness or when