Filter
Top Products
Rev. 0608
11
Maintenance
ALWAYS DISCONNECT ELECTRICAL POWER
AT THE MAIN DISCONNECT WHEN SERVICING
OR REPLACING ANY ELECTRICAL COMPONENT.
This includes (but not limited to) Fans, Heaters,
Thermostats, and Lights.
Replacing Overhead Heat Lamps
Overhead Halogen and Merco lamps are designed to
last through many hours of use. Should there be a need
to replace one, it is as simple as replacing a standard
uorescent light bulb.
The Heat lamps used in these cases get
EXTREMELY HOT! NEVER touch a lamp
until the case has had ample time to cool
down! It is also highly recommended to handle
lamps with gloves or use a cloth rag - not just
for the heat factor, but also the oils in your
fingers will drastically shorten the life of the lamp.
1. Turn light switch to OFF before replacing any
lighting components.
2. Disconnect light xture by removing power cord
from socket in the right rear interior corner of the
merchandiser.
3. Place the shelf on a at surface to remove the clear
plastic protective shield from the xture. Carefully
insert one nger between the xture socket and
the protective shield. Use other hand to “pinch”
lens cover (and simultaneously hold the xture in
place) while lifting with inserted nger.When shield
separates from xture at one end, remove it by
SLOWLY pulling remainder of shield away from
xture.
4. Remove lamp by depressing spring loaded socket
at end of xture, and swinging opposite end of lamp
from it’s former position.
5. Using gloves or covering for lamp, insert new lamp
into spring loaded socket, depressing socket until
opposite end of lamp properly enters stationary light
socket.
6. Return lamp to original position by lightly pinching it
in from each side, and inserting shield anges into
xture channel. Continue process along length of
lamp shield until it is in it’s nal proper position.
7. Return lamp to original position by lightly pinching it
in from each side, and inserting shield anges into
xture channel. Continue process along length of
lamp shield until it is in it’s nal proper position.