Filter
Top Products
Installation Limitations
• Do not install your refrigerator in any location not properly insulated or heated,
e.g. garage, etc. Your refrigerator was not designed to operate in temperature
settings below 55˚ Fahrenheit.
• Select a suitable location for the refrigerator on a hard even surface away
from direct sunlight or heat source, e.g. radiators, baseboard heaters, cooking
appliances, etc. Any floor unevenness should be corrected with the leveling legs
located on the front bottom corners of the refrigerator.
Door Alignment
Freezer Door: (see fig. #1)
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the top hinge cover.
Reversing the Door (See Fig. #4)
1. Remove the top hinge cover. (See Fig. #1)
2. Using Phillips Head Screwdriver, loosen and remove the
screws holding the top hinge in place.
3. Remove top hinge and carefully lift off the
freezer door.
4. Remove the screw hole plugs from the
opposite side and insert the plugs in the
screw hole openings of the just removed
screws.
5. Open refrigerator Door and unscrew 2 screws from the center hinge bracket
while holding the open door in place. (See Fig. #2)
6. Remove bracket and lift off refrigerator door
7. While doors are removed unscrew the door stoppers and reinsert on opposite
side of door. (See Fig. #3)
8. Remove the screw hole plugs from the opposite side and insert the plugs in the
screw hole openings of the just removed screws.
9. Remove any loose items in the refrigerator and
carefully tilt refrigerator and lean against wall.
Remove both leveling legs and place in a secure
area.
10. Loosen the screws holding the lower hinge bracket
to the refrigerator door and remove screws and
bracket. Remove leveling leg
1
0
2
3
4
5
6
7
5
English
Fig. #1
Fig. #2