7
Display
When power is first supplied to the microwave oven, a “:” will
blink on the display. Touch OFF/CANCEL to stop the blinking.
If the “:” blinks on the display at any other time, a power failure
has occurred. Touch OFF/CANCEL and reset the clock if needed.
If “RETRY” blinks on the display for 1 second, an invalid value
has been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.
Start/Enter
The START/ENTER pad begins any function. If not touched after
touching a pad, “START?” will appear in the display.
If cooking is interrupted, touching START/ENTER will resume the
preset cycle.
Off/Cancel
The OFF/CANCEL pad clears any incorrect command and
cancels any program during cooking. It will not erase the time
of day.
The microwave oven will also turn off when the door is opened.
Close the door and touch START/ENTER to resume the cycle.
Add A Minute
Cook time may be added in 1-minute increments, up to
99 minutes, by touching the Add A Minute pad.
Touching ADD A MINUTE during a cook cycle will add 1 minute of
cook time at the current cook power.
Touching ADD A MINUTE when the microwave oven is not in use,
or after a cook cycle has ended, will start the microwave oven for
1 minute of cook time at 100% cook power.
Number Codes
The microwave oven is preset with shortcut number codes. A
number code includes one or more of the following: cooking
power, cook time and food quantity or weight. See the charts in
the “Reheating” section for additional information.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START/ENTER.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear, and “:” will appear on the display.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid entry (short tone)
■ End of Timer countdown (long tone) (on some models)
Two tones
■ End of stage in multistage cooking
■ Reminder, repeat each minute after the end-of-cycle tones
■ Control Lock active
■ Hidden feature has been entered or exited
Three tones
■ Invalid entry
Four tones
■ End of cycle
To Turn Off/On Valid Entry Tones: Touch and hold the number
pad “1” for 5 seconds until 2 tones sound. Repeat to turn tones
back on.
To Turn Off/On All Tones: Touch and hold the number pad “2”
for 5 seconds until 2 tones sound. Repeat to turn tones back on.
Timer
The Timer can be set in minutes and seconds, up to 99 minutes
99 seconds and counts down the set time.
NOTE: The Timer does not start or stop the microwave oven.
When the Timer is in use, the microwave oven can also operate.
To see the countdown for 5 seconds when the microwave oven is
in use, touch TIMER SET/OFF.
To Set:
1. Touch TIMER SET/OFF.
If no action is taken after 1 minute, the display will return to
the time of day mode.
2. Touch the number pads to set the length of time.
3. Touch TIMER SET/OFF or START/ENTER.
If not touched within 5 seconds, “START?” will appear on the
display. If not touched within 1 minute, the display will return
to the time of day mode and the programmed function will be
canceled.
When the set time ends, “END” will appear on the display and
1 tone will sound.
Remember, touching OFF/CANCEL while a cook function is
active in the display will cancel the cook function, not the
Timer.
4. Touch TIMER SET/OFF at any time to cancel the Timer.
The length of time can be changed during the countdown by
repeating the above steps.
Control Lock
The Control Lock shuts down the control panel pads to prevent
unintended use of the microwave oven.
When the control is locked, only the Vent Fan and Light pads will
function.
To Lock/Unlock Control: The microwave oven and Timer must
be off. Touch and hold OFF/CANCEL for 5 seconds until 2 tones
sound and a lock icon appears on the display. Repeat to unlock
and remove the lock icon from display.