Cornelius 569000208 Beverage Dispenser User Manual


  Open as PDF
of 2
 
2560001744
3. Remove electrical control box cover. Remove mounting template from the refrigeration deck, then
install new AGITATOR MOTOR ASSEMBLY (item 1) on the refrigeration deck (see Figure 3) and
secure with two SCREWS (item 2).
4. Connect agitator motor assembly electrical wires to L
1
and L
2
terminals on the PC board inside the
electrical control box as shown in Figure 4.
5. Install cover on the electrical control box. MAKE SURE AGITATOR MOTOR WIRES ENTERING
THE ELECTRICAL CONTROL BOX ARE NOT PINCHED.
6. Install hood on the Dispenser, then connect electrical power to the Dispenser. Check Dispenser for
proper operation.
FIGURE 1.
FIGURE 2.
FIGURE 3. FIGURE 4.
A
B
OLD AGITATOR
MOTOR
ELECTRICAL CONTROL
BOX COVER
P.C.
BOARDS
ITEM 3
AGITATOR MOTOR
MOUNTING TEMPLATE
FRONT
MOUNTING TEMPLATE
(ITEM 3)
APPLY TO
REFRIGERATION DECK
AGIT. MTR.
LEADS
ITEM 2
MOUNTING TEMPLATE
(ITEM 3)
REFRIGERATION
DECK
SLINGER
(DO NOT MOVE)
AGIT. MTR.
PUMP
JUMPER
RIBBED COMP
SERV CORD
COND. AREA
AGIT. PORT
CUTOUT
o
o
 previous