Filter
Top Products
Icemaker & Adaptor Hold-Down Kit Installation Instructions
Publication Number: 629096853INS - 6 - © 2008, IMI Cornelius Inc.
Figure 12
7. Using the supplied sheetmetal screws, screw four (4) screws per plate into the dispenser wrapper and
icemaker base.
8. Repeat Steps 2 through 7 on the other side of the dispenser.
INSTRUCTIONS FOR NON-30 INCH WIDE ICEMAKER – IDC SERIES UNITS
WARNING: Failure to follow the installation instructions correctly may result in equipment damage
and/or personal injury.
The Parts shown in Table 4 are NOT Used for this Installation:
1. Locate the two right and left side hold down brackets, shown in Figure 2. These are the brackets with the
bent flange on them.
2. Position bracket with the straight edge towards the rear of the unit, as shown in Figure 13. Also, the flange
of the bracket must be over the adapter lid, as shown in Figure 4.
Figure 13
3. Using the bracket as a template, drill two 9/64 in. (0.140 in.) holes in the dispenser wrapper.
CAUTION: Be careful not to drill too deep and/or too fast into the dispenser wrapper as damage may
occur to unseen parts.
Table 4
Part No. Description Qty.
620518916 Adaptor/Icemaker Side Hold-Down Plate (Flat) 2
Straight Edge of
Bracket Goes to
the Rear of the
Dispenser