Filter
Top Products
Icemaker & Adaptor Hold-Down Kit Installation Instructions
Publication Number: 629096853INS - 4 - © 2008, IMI Cornelius Inc.
CAUTION: Be careful not to drill too deep and/or too fast into the icemaker base and dispenser
wrapper as damage may occur to unseen parts.
Figure 7
9. Install the second mounting plate on the other side of the icemaker base. Using supplied sheetmetal
screws, screw four (4) screws per plate into the icemaker base and dispenser wrapper.
INSTRUCTIONS FOR 30 INCH WIDE ICEMAKERS – FLAVOR FUSION UNITS
CAUTION: Failure to follow the installation instructions correctly may result in equipment damage
and/or personal injury.
The Parts shown in Table 3 are NOT Used for this Installation:
1. Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 8.
Figure 8
2. Remove the two top black side panel screws from both sides of the Flavor Fusion unit (See Figure 1) and
save the screws.
Table 3
Part No. Description Qty.
22127 Icemaker Rear Mounting Plate 2
620053922 Left Side Adapter Hold-Down Bracket 1
620053923 Right Side Adapter Hold-Down Bracket 1