Filter
Top Products
2
620912201
3. Place (2) sealing washers (item 9) over studs and (2) flat washers (item11), then fasten in place with (2)
plastic acorn nuts (item 8).
4. Set ice maker lid on the top of the dispenser.
5. Using the slotted holes in the lid as a template, drill four (4) .140I diameter (9/64I) holes at the bottom of
the slots (see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with
four (4) #8 sheet metal screws, two on each side.
6. Seal the ice maker to the top of the dispenser as follows:
A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away the excess RTV.
7. Drill 9/64I diameter holes into the ice maker cabinet using the bracket as a template. Use extreme care not
to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using the screws pro-
vided
8. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the
bin thermostat if so equipped or required.
9. If the plastice acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary
to make small notches in the back flange of the cover to clear the acorn nuts.
NOTE: Bin Thermostat must not interfere with the agitator rotation.