Filter
Top Products
2
620909401
B. Set the ice maker onto the lid and position it as required.
C. Wipe away the excess RTV.
7. Remove the two rear screws (only) installed in step 5. Use those screws to install the mounting brackets
(item3). Drill 9/64I diameter holes into the ice maker cabinet using the bracket as a template. Use extreme
care not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using the
screws provided
8. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the
bin thermostat if so equipped or required.
9. If the plastice acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary
to make small notches in the back flange of the cover to clear the acorn nuts.
NOTE: Bin Thermostat must not interfere with the agitator rotation.