Filter
Top Products
EIMI Cornelius Inc; 1998
October 27, 1998
6
2
0
9
1
3
5
0
1
REV:A
Cornelius Incorporated
500 Regency Drive
Glendale Heights, IL 60139
Telephone (630) 980-6900
Facsimile (630) 980-8511
ICEMAKER ADAPTER KIT (P/N 629085001)
This Icemaker Adapter Kit (P/N 629085001) is for the following Units:
Dispenser Model Icemaker Model
ED200/250 Wilshire WCC500/700
Table 1. Adapter Kit Parts
Item
No. Part No. Name Qty.
1 620032802 Icemaker Adapter Lid 1
2 22128 Bracket, Icemaker Mounting 2
3 50904 RTV, 3-Oz. Tube 1
4 620032804 Cover, Manual Ice Fill 1
5 70226 #10 Sheet Metal Screw 12
6 70188 Thumb Screw, #8--32X3/8--in. Long 1
7 620913501 Installation Instructions 1
CAUTION: Disconnect electrical power from the Dispenser before attempting to install this
Kit.
1. Remove merchandiser from the Dispenser by lifting up on both the right and the left sides to disengage the
merchandiser from slots in the Dispenser cabinet. Tilt the merchandiser forward from the top and lift off.
NOTE: Disregard step 2 if the ice diverter has been factory installed.
2. Refer to Figure 4 for the following:
A. Remove the ice chute cover (snap-fit) and ice chute (4 nuts).
B. Remove the gate restrictor and discard.
C. Install the ice diverter as shown.
D. Replace the ice chute and cover.
3. Refer to Figure 3 for adjusting the automatic agitation timer.
A. Loosen/rotate the center mounting screw that secures the white reflector panel/electrical control box
cover in place and lower the cover to expose the automatic agitation timer.
B. Adjust the timer to 2-seconds “ON” and 1-hour “OFF” as shown in Figure 3.
C. Reinstall the white reflector panel and the merchandiser.