Filter
Top Products
2
620917305
B. Set the Icemaker onto the lid. Note: If installing the Icemaker from front of the Dispenser, use a
length of 3/4--inch diameter or larger PVC pipe as a “roller” to slide the Icemaker over the front
“drip” flange of the Dispenser lid.
C. Wipe away any excess RTV.
4. Using the slotted holes in the adapter lid as a template, drill four (4) .147 diameter holes (No. 26 drill) into
the Dispenser cabinet (see detail A of Figure 1). Use extreme care not to drill into the ice storage bin.
Secure the lid to the Dispenser with four (4) No. 10 sheetmetal screws.
5. Install Icemaker mounting brackets two (2) as shown in Figure 1. Using the brackets as templates, drill
.147 inch diameter holes into the Icemaker cabinet and the adapter lid. Use extreme caution not to drill
into any Icemaker components (condenser, tubing, etc.). Secure the brackets to the Icemaker cabinet
with the No. 10 sheetmetal screws provided in the kit.
6. Follow the Icemakers Manufacturer’s instructions to complete installation of the Icemaker.
7. IMPORTANT: The bin thermostat bracket (item 7) must be installed (see Figure 2) in order to pre-
vent overfilling the ice storage bin
A. Remove the Icemaker front panel.
B. Locate the bin thermostat on the lower--right side wall of the ice drop area and remove the two (2)
thumbscrews that hold the bin thermostat in place.
C. Mount the bin thermostat to the bracket (item 7) provided with the kit as shown in Figure 2.
D. Using the thumbscrews from step B preceding, secure the “kit” bracket/bin thermostat assembly from
step C preceding to the same ice drop area position. The purpose of this “kit” bracket is to lower the
bin thermostat for proper filling of the ice storage bin.
E. Replace the Icemaker front panel.
8. Install the caution label (item 10) on the manual fill cover (item 2) and secure the cover to the adapter lid
with the No. 8--32 thumbscrew.
9. The Icemaker/Dispenser is ready for operation.
NOTE: Bin Thermostat must not interfere with the agitator rotation.