Cornelius P/N 629088756 Ice Maker User Manual


  Open as PDF
of 2
 
IDC 255 Icemaker Adaptor Kit Installation Instructions
Publication Number: 629088756INS - 2 - © 2006, IMI Cornelius Inc.
4. Place the icemaker on top of kit and adjust it so that only 3.096” of it protrude outside the IDC
wrapper, as shown in FIGURE 2. DO NOT slide icemaker into position on the lid.
FIGURE 2
5. Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent),
supplied in kit to seal the icemaker to the top of the adapter kit. All excess sealant must be wiped
away immediately.
6. Secure the icemaker to the adapter by drilling 9/64” diameter holes, using one of the two brackets
supplied in the kit, into both the rear of the icemaker and rear of the icemaker adapter kit. Use
extreme care not to drill into any icemaker components!!! Secure the brackets using the screws
provided.
7. For optimal performance, do not fill ice bin more than 2/3 capacity (maximum fill is 4” below top of
bin). Applies to IDC 255 models and nugget ice only.
NOTE: Adaptor kits are only approved for top mounting a single icemaker.
3.096
 previous