Filter
Top Products
8
GB
Using the freezer to its full potential
• Use the FREEZER OPERATION knob to adjust the
temperature (
see Description
).
• Do not re-freeze food that is defrosting or that has already
been defrosted. These foods must be cooked and eaten
(within 24 hours).
• Fresh food that needs to be frozen must not come into
contact with food that has already been defrosted. Fresh
food must be stored in the top FREEZER and STORAGE
compartment where the temperature drops below -18°C
and guarantees rapid freezing.
• Do not place glass bottles which contain liquids, and
which are corked or hermetically sealed in the freezer
because they could break.
• The maximum quantity of food that may be frozen daily is
indicated on the plate containing the technical properties
located on the bottom left side of the refrigerator
compartment (for example: Kg/24h: 4).
• To freeze (if the freezer is already operating):
- for small quantities which are less than those indicated on
the data plate, press the rapid freezing SUPER FREEZE
button (corresponding yellow indicator light illuminates),
insert the food and close the door. The function is disabled
automatically after 24 hours or when optimal temperatures
have been reached (indicator light goes out);
- for large quantities which are greater than the maximum
load indicated on the data plate, hold down the rapid
freezing SUPER FREEZE button until the corresponding
indicator light begins to flash. After 24 hours the indicator
light stops flashing and remains on constantly. Place the
food inside the freezer and close the door. After another 24
hours, the function will be disabled automatically (indicator
light goes out).
! Do not open the door during freezing.
! If there is a power cut or malfunction, do not open the
freezer door. This will help maintain the temperature inside
the freezer, ensuring that foods are conserved for at least 9
-14 hours.
MAX
WATER LEVEL
MAX
WATER LEVEL
ICE trays: to make ice.
1. Pull out the tray by pushing
it up and then outwards (
see
diagram
).
Check that the tray is completely
empty and fill it with water
through the opening provided.
2. Take care not to exceed the
level indicated (MAX WATER
LEVEL). Excess water prevents
the ice cubes from dispensing
(if this happens, wait for the ice
to melt and empty the tray).
3. Turn the tray 90°: the water
fills up the moulds (
see
diagram
). Close the opening
with the lid and replace. When
the ice has formed (minimum
time approximately 8 hours),
knock the tray against a hard
surface.