Filter
Top Products
3
GB
Salt, Detergent and Rinse Aid ....
Salt
The hardness of the water varies from place to place. If
hard water is used in the dishwasher, deposits will form on
the dishes and utensils.
The appliance is equipped with a special softener that uses
a salt specifically designed to eliminate lime and minerals
from the water.
Loading the Salt into the Softener
Always use salt intended
for use with dishwashers.
The salt container is located
beneath the lower rack
and should be filled as
follows:
1. Remove the lower rack
and then unscrew and
remove the cap from the
salt container;
2. If you are filling the
container for the first time,
fill it with water;
3. Place the end of the funnel (supplied) into the hole and
introduce about 2 kg of salt. It is normal for a small amount
of water to come out of the salt container.
4. Carefully screw the cap back on.
The salt container should be filled after about every
30 wash cycles.
Warning: To prevent rust from forming , we advise you to
load the salt before beginning a wash cycle.
Detergent
Detergent specifically intended for use with dishwashers must
be used. The dispenser must be refilled before the start of
each wash cycle following the instructions provided in the
"Wash Cycle Table." The detergent dispenser is located on
the inside panel of the door.
Loading the detergent
To open lid "A", press button "B". The cleaning detergent
should be introduced into the two containers "C"and "D"
up to the rim.
After pouring in the detergent, replace the lid, pressing down
until it clicks.
Dishwasher detergent in tablets is now available on the
market, in which case you should place one tablet into
container "D" and replace the lid.
Notice: To facilitate closing the cover, remove any
excess detergent on the edges of the dispenser.
Rinse Aid
This product makes dishes sparkle more as it improves their
drying. The rinse aid container is situated on the inside of the
appliance door; you should refill it when you see the container
is empty by means of indicator light “D”.
(If your dishwasher is fitted with a “low rinse aid” indicator
light, fill the container up when the indicator light flashes or
lights up).
Loading the Rinse Aid
To open the dispenser, turn the "C" cap in the anti-clockwise
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the "F" dose adjustor, located beneath
the "C" cap, with a screwdriver. There are 6 different
settings; the normal dosage setting is 4.
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjustor should be turned to a higher setting. If
the dishes have white streaks, turn the dosage adjustor to a
lower setting.
C
A
B
D
5
gr.
25
gr.
C
F
D
Warning
Three-in-one dishwasher tablets are now available on the
market, and combine the detergent, salt and rinse aid all in
one. If the water in your area is hard or very hard, we still
recommend you pour extra salt into the relevant dispenser
to prevent the formation of white streaks on your dishes or
on the appliance interior.
Add rinse aid to the corresponding container only if you are
dissatisfied with the results on your dishes.
In any case, please read the manufacturer's instructions
provided on the packet.