Filter
Top Products
6
GB
Starting the Appliance
Starting a wash cycle....
After performing all the operations described in the previous
paragraphs, turn the water tap on completely, open the
appliance door and press ON-OFF button "A": indicator light
"B" comes on. Your appliance is now on and awaiting
instructions.
Setting and Starting a Wash Cycle
Select the wash cycle by pressing button "P". Each time this
button is pressed, one of the indicator lights "C" will come
on in sequence, select the wash cycle you deem most
suitable for the type of dishes to wash (take a look at page
7, where you will find the wash cycle table). Close the
appliance door and after a few seconds, you will hear a
short beep: the wash cycle has begun.
Cancelling or modifying a cycle while underway...
Premise: A cycle that is underway can only be modified if it
has only been running for a short time.
Open the appliance door carefully to avoid any hot water
splashes, then keep button "P" pressed for approximately 5
seconds, until you hear 3 short beeps. Indicator light "C"
will come off and at this point, all the settings will have
been cancelled. You are now free to re-set the correct wash
cycle.
If you forget to load some of the dishes...
Interrupt the wash cycle by opening the appliance door with
the utmost care, as usual, then insert the dish you had
forgotten. When you shut the appliance door, the cycle will
start up from where you interrupted it. restart at the point
where it left off.
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when you close the door.
At the end of the wash cycle...
The end of the wash cycle is indicated by a double beep and
the flashing of the wash cycle indicator light "C". Open the
dishwasher door, press the ON-OFF button as well, thus cutting
off the electricity supply to the appliance.
- Turn off the water tap.
CAUTION
Turn the display off by pressing button “A”, unplug
the appliance from the electricity socket to cut off the
power supply; the power supply cable should
consequently be easily accessible.
Wait a few minutes before unloading the dishes: they are
very hot! If you wait a little while, they dry better thanks to
the steam.
Empty the lower rack first.
Make sure the wash cycle has ended before removing the
dishes!
Warning
If opening the door soon after the end of the programme,or
during it, stand away from the Dishwasher, to avoid possible
injury from hot steam.