Filter
Top Products
6
GB
Analogue programmer
Setting the time
Press the PROGRAMMER knob and turn it
anticlockwise to set the correct time.
! The clock can only be set if the oven is connected to
the mains. In case of a power failure, the
PROGRAMMER will stop: the correct time will have to
be reset.
Starting the oven
1. Turn the PROGRAMMER knob anticlockwise
until the 9 symbol is displayed.
2. Pull the PROGRAMMER knob and turn it
anticlockwise until the knob marker lines up with the
current time. A click will indicate the end of the
programming phase.
3. Select the desired cooking mode using the
SELECTOR knob.
4. To turn the oven off, set the SELECTOR knob
back to the 0 position.
Programming your cooking
Programming instant cooking time
1. Turn the PROGRAMMER knob anticlockwise
until the desired cooking time is displayed.
2. Pull the PROGRAMMER knob and turn it
anticlockwise until the knob marker lines up with the
current time. A click will indicate the end of the
programming phase.
3. Select the desired cooking mode using the
SELECTOR knob. The oven comes on immediately
and stays on for the entire duration of the set cooking
time.
4. When the selected time has elapsed, a buzzer
will sound and the oven will turn off.
For example: it is 9:00 a.m. and a time of 1 hour
and 15 minutes is programmed. The programme
stops automatically at 10:15 a.m.
Programming a delayed cooking time
1. Turn the PROGRAMMER knob anticlockwise
until the desired cooking time is displayed.
2. Pull the PROGRAMMER knob and turn it
anticlockwise until the knob marker lines up with the
desired cooking start time.
3. Select the desired cooking mode using the
SELECTOR knob. The oven will come on at the set
cooking start time and will stay on for the entire
duration of the set cooking time.
4. When the selected time has elapsed, a buzzer
will sound and the oven will turn off.
For example: it is 9:00 a.m. and a time of 1 hour
and 15 minutes is programmed and the start time is
set to 11:00. The programme starts automatically at
11:00 and ends at 12:15.
! To cancel programming, turn the PROGRAMMER
knob anticlockwise until the symbol 9 is displayed.
12
3
6
9