Filter
Top Products
7
GB
Setting a half load and a delayed start
How to set a delayed start
When you have loaded the dishes, you can choose when to
start your dishwasher before setting the wash cycle desired.
• Press button "G" repeatedly to postpone the start of the
wash cycle from 1 hour to 24h.
• If you press the button again, the word "OFF" is displayed
(no selection made).
Once you have made your selection, make sure the appliance
door is shut and start the wash cycle by pressing the START
button.
Symbol "I" lights up on the display and the countdown
begins.
• Once the countdown is up, the wash cycle begins and the
approximate amount of time left until the end of the wash
cycle is displayed.
Have you changed your mind?
• If you change your mind, you can set a shorter time delay:
press button "G" to select it. You need not reset the wash
cycle.
• If you have changed your mind and wish to start the wash
cycle immediately, press button "G" until the countdown is
fully reset. Indicator light "I" will turn off and the cycle will
start at the sound of a beep.
The indicator light corresponding to the cycle phase under
way will come up on the display and the countdown to the
estimated cycle end begins.
You want to wash on one rack only?
Remember to use half the amount of detergent.
When you only have little cutlery to wash, you can run just
half a load on the upper rack, saving on both water and
electricity.
• Press button "F"; you will hear a beep and the symbol
corresponding to the half load will light up.
Once you have made your setting, start the wash cycle by
pressing the START button.
- This option is available with all wash cycles.
- The Just You wash cycle is programmed to wash on the
upper rack only.
Warning: if the display indicates the word "dON" when you turn
your dishwasher on, this means the demo mode is in operation. This
mode is useful for exhibitors in that it simulates the wash cycles
without actually carrying them out.
To quit this mode, keep the START/RESET button "R" pressed for
approximately 4 seconds. The word "dOF" will be displayed once
you have quit the demo mode successfully.