Filter
Top Products
7
EN
A
B
D
C
Start-up and use
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button: the display will light up.
3. Measure out the detergent (
see below
).
4. Load the racks (see Loading the racks) and shut the door.
5. Select the programme by turning the WASH CYCLE
SELECT knob in a clockwise direction: align the notch on the
knob with the number or symbol representing the desired
wash cycle.
6. Select the wash options (
see below
).
7. Start the cycle by pressing the START/RESET button: the
machine will emit a confirmation beep. The WASH CYCLE
PHASE indicator lights display the status of the cycle: Pre-
wash, Wash, Rinse, or Drying.
8. At the end of the cycle three short beeps will sound and
END will appear on the display. Switch off the appliance by
pressing the ON/OFF button, shut off the water tap and
unplug the appliance from the electricity socket.
9. Open the door and wait for a few minutes before removing
the crockery, in order to avoid burns. Unload the racks,
beginning with the lower level.
Demo*
If dON appears on the display, this means that the appliance
is in demonstration mode. To deactivate it, press the START/
RESET and ON/OFF buttons simultaneously: dOF should
appear on the display.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that it has
only just begun: press and hold the START/RESET button for 4
seconds. After one long beep and three short beeps, the
WASH CYCLE PHASE indicator light will switch off. Select the
new cycle and switch the machine back on by pressing the
START/RESET button.
Adding extra crockery
Press the ON/OFF button and open the door, taking care to
avoid the escaping steam, and place the crockery inside the
dishwasher. Press the ON/OFF button again: the cycle starts
from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply is restored.
Loading the detergent
A successful wash also depends on the correct amount of
detergent being used, as recommended by the manufacturer.
Exceeding the recommended amount does not result in a
more effective wash and pollutes the environment.
To obtain the best results from each washing and drying
cycle, powder detergent, rinse aid liquid and salt should be
used.
compartment Acompartment A
compartment Acompartment A
compartment A: Washing
detergent
compartment Bcompartment B
compartment Bcompartment B
compartment B: Pre-wash
detergent
1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the
Wash cycle table
:
• for powder detergent use
compartments A and B
• for tablets, use compartment A
and the bottom of the appliance,
i.e. when the cycle requires 1 tablet, place it in compartment A
and close the cover; when it requires 2, place the second
tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Delayed start
It is possible to delay the start time of the cycle for a period of
time between 1 and 24 hours.
1. Press the DELAYED START button: every time the button is
pressed, the time selected appears on the display and the
delayed start indicator light illuminates.
2. Select the wash cycle and press the START/RESET button:
after the beep sounds, the timer begins counting down.
3.Once this time is up, the indicator light switches off and the
wash cycle begins.
To adjust the delay time and select a lower period of time,
press the DELAYED START button. To cancel it, press the
button repeatedly until the wash cycle begins and the WASH
CYCLE PHASE indicator light corresponding to the start of the
cycle in progress illuminates.
Half load using the upper rack*
If there are not many dishes to be washed, a half load cycle
may be used in order to save water, electricity and detergent.
Before selecting the wash cycle press the HALF LOAD button
repeatedly: the indicator light will illuminate and the wash cycle
will take place only in the upper rack.
Remember to load the upper rack only, and to reduce the
amount of detergent accordingly.
It is better to use powder detergent in this case.
Extra drying*
To make sure that the crockery is completely dry at the end of
the cycle, press the EXTRA DRYING button before selecting
the wash cycle. A prolonged beep will sound to indicate that
this option has been selected and a short beep will sound to
indicate when it has been deselected.
If the Extra drying option is selected, the wash cycles will
last longer.