Filter
Top Products
7
EN
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will illuminate.
3. Open the door and pour in a suitable amount of detergent
(see below).
4. Load the racks (see Loading the racks) and shut the door.
5. Select the wash cycle end time by turning the SELECTOR
knob between:
•
30 min, 60 min, 90 min, 3h*,6h*,9h* 30 min, 60 min, 90 min, 3h*,6h*,9h*
30 min, 60 min, 90 min, 3h*,6h*,9h* 30 min, 60 min, 90 min, 3h*,6h*,9h*
30 min, 60 min, 90 min, 3h*,6h*,9h*
(see delayed start
section)
, setting the type of wash required based on the
crockery and how soiled it is
(see table of wash cycles).
•
Auto4you wash cycle: Auto4you wash cycle:
Auto4you wash cycle: Auto4you wash cycle:
Auto4you wash cycle:helps to achieve the best washing
and drying results in a short space of time
(see table of wash
cycles).
6. Select the wash options
(see below).
7. Start the cycle by pressing the START/RESET button: the
machine will emit a confirmation beep. the WASH CYCLE IN
PROGRESS indicator light will illuminate.
8. During the cycle the REMAINING TIME indicator lights
illuminate to show:
o 20 minutes from the end of the wash cycle
o 10 minutes from the end of the wash cycle
9. At the end of the cycle three short beeps will sound and the
WASH CYCLE COMPLETE indicator light will flash.
10. Switch off the appliance by pressing the ON/OFF button,
shut off the water tap and unplug the appliance from the
electricity socket.
11. Open the door and wait for a few minutes before removing
the crockery, in order to avoid burns. Unload the racks,
beginning with the lower level.
Modifying the duration of a wash cycle already in
progress
If the wrong programme was chosen originally, it may be
changed within one minute from when the WASH CYCLE IN
PROGRESS indicator light illuminates: Press and hold the
START/RESET button for 4 seconds; you will hear one long
beep followed by three short ones. Restart the machine by
pressing the START/RESET button.
Adding extra crockery
Press the ON/OFF button and open the door, taking care to
avoid the escaping steam, and place the crockery inside the
dishwasher. Press the ON/OFF button again: the cycle starts
from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a
power cut, the cycle stops. It starts again from the point at
which it was interrupted once the door has been shut or the
electricity supply is restored.
Loading the detergent
A successful wash also depends on the correct amount of
detergent being used, as recommended by the manufacturer.
Exceeding the recommended amount does not result in a
more effective wash and pollutes the environment.
compartment Acompartment A
compartment Acompartment A
compartment A: Washing
detergent
compartment Bcompartment B
compartment Bcompartment B
compartment B: Pre-wash
detergent
1. Open cover C by pressing
button D.
2. Pour in the detergent after
consulting the
Wash cycle
table
:
• for powder detergent use
compartments A and B
• for tablets, use compartment A and the bottom of the
appliance, i.e. when the cycle requires 1 tablet, place it in
compartment A and close the cover; when it requires 2, place
the second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
Washing options
Delayed start
This dishwasher gives the user complete control over the
wash cycle timing. The 3h, 6h and 9h cycles enable the
dishwasher to achieve its best performance, at the exact time
required, by using the AUTO4YOU programme.
It is important to remember that:
• if the 3h cycle has been selected the dishwasher will wail for
30 minutes and then wash for the remaining 150 minutes
• if the 6h cycle has been selected the dishwasher will wail for
3 hours and 30 minutes and then wash for the remaining 150
minutes
• if the 9h cycle has been selected the dishwasher will wail for
6 hours and 30 minutes and then wash for the remaining 150
minutes
To cancel or change the cycle, press the START/RESET button
and after the beeps have been emitted reselect a new cycle.
Restart the cycle using the START/RESET button.
3in1 button*
When using multi-use tablets (2-in-1, 3-in-1, 4-in-1), press the
3in1 button. The overall duration of the programme increases
by approximately 10 minutes when this function is used.
! This option is incompatible with the 30-minute cycle.
A
B
D
C
Start-up and use
* Only available in selected models.