Filter
Top Products
9
The cooker with gas oven
A Tray for Catching Overflows
B Gas Burner
C Instantaneous Electronic Lighting Device
D Top Grate
E Control Panel
F Adjustable Feet or Legs
G Dripping Pan or Baking Sheet
H Flame Failure Device for Cooktop Burners (only a
few models)
K Oven Rack
L Electronic Lighting for Hob Burners
M Oven Control Knob
N Control Knobs for Gas Burners on Hob
O Button for Oven and Rotisserie Light
P Timer Knob
The different functions and uses of the oven
The various functions included in the cooker are selected
by operating the control devices located on the cooker
control panel.
Control Knobs for the Gas Burners on the Hob
The position of the gas burner controlled by each one of
the knobs is shown by a symbol of a solid ring:•. To light
one of the burners, hold a lighted match or lighter near
the burner. Press down and turn the corresponding knob
in the counter-clockwise direction to the maximum
setting. Each burner can be operated at its maximum,
minimum or intermediate power. Shown on the knob are
the different symbols for off • (the knob is on this setting
when the symbol lines up with the reference mark on the
control panel), for maximum and minimum .
To obtain these settings, turn the knob counter-clockwise
with respect to the off position. To turn off the burner, turn
the knob clockwise until it stops (corresponding again with
the • symbol).
Electronic Lighting of the Hob Burners
Some models are equipped with instant electronic light-
ing of the gas burners located on the hob, which can be
identified by the presence of an igniter device (see detail
C). This device is activated by lighting pressing on the “L”
button, identified by the symbol. To turn on a burner,
simply press the “L” button and then press while, at the
same time, pressing in and turning the control knob for
the burner in the anticlockwise direction until the burner
lights. To light the burner immediately, it is recom-
mended that the button be pressed first and then the
knob turned.
Caution: If the burner accidentally goes out, turn off
the burner using the knob and wait at least one minute
before relighting.
Models with Flame Failure Device
These models are identified by the presence of a flame
detection device (see detail H).
Important: Since the top burners are equipped with a
safety device, after lighting the burner keep the knob
pressed in for about 6 seconds to allow the gas to pass
until the safety thermocouple is heated.
Gas Cut Off
This cooker has a safety cut out feature which switches
off the burners when you close the cover. This device is
provided as a safety feature in case the cover is lowered
F
A
E
K
G
D
B
MOPL N
C
H