Filter
Top Products
GB
11
Care and maintenance
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
! Do not use abrasive or corrosive detergents (for
example, products in spray cans for cleaning
barbecues and ovens), stain removers, anti-rust
products, powder detergents or sponges with
abrasive surfaces: these may scratch the surface
beyond repair.
! Never use steam cleaners or pressure cleaners on
the appliance.
To extend the life of your oven, it must be cleaned
frequently, keeping in mind that:
• The self-cleaning panels (if present) and the
enameled parts should be washed with warm water
- abrasive powders and corrosive substances
should be avoided;
• The inside of the oven should be cleaned
immediately after use with warm water and soap;
the soap should be rinsed away and the interior
dried thoroughly;
• Stainless steel can be stained if it remains in
contact with agressive detergents (containing
phosphorus) or water with a high lime content. We
recommend that you rinse these parts thoroughly
and dry them well after cleaning. It is also a good
idea to dry any water spills;
• Never line the bottom of the oven with aluminium foil
because the buildup of heat will not only impede
the cooking process, but could also damage the
enamel.
Changing the oven light bulb
• Cutoff the supply of power to the oven by turning off
the omni-polar switch connecting it to the mains, or
by removing the plug if it is accessible;
• Unscrew the glass cover attached to the lamp
holder;
• Unscrew the lamp and replace it with another high-
temperature lamp (300°C) with the following
characteristics:
- Voltage: 230/240 V
- Wattage: 15W
- Socket: E14
• Remount the glass cover
and reconnect the
appliance to the power
supply.
Disassembling/assembling the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack. To
clean more thoroughly, you can remove the oven door:
• Open the door completely and lift the 2 levers “B”;
• Now, shutting the door slightly, you can lift it out by
pulling out the hooks “A” as shown in figure.
To reassemble the door:
• With the door in a vertical position, insert the two
hooks “A” into the slots;
• Ensure that seat “D” is hooked perfectly onto the
edge of the slot (move the oven door backwards
and forward slightly);
• Keep the oven door open fully, unhook the 2 levers
“B” downwards and then shut the door again.