Filter
Top Products
UNPACKING THE COOKER
Unpack the components from inside the grill and oven: Check that the following parts
are present.
Grill pan and grid Pan supports
Main oven shelves (2) Enamelled burner caps (4)
Small pan support trivet Aluminium burner bodies(4)
Literature
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)
Each burner requires the injector to be replaced and bypass screws adjusted or replaced as
follows:
1. Remove the loose hotplate burner parts.
2. Using a 7mm socket, replace the hotplate injectors as appropriate (see table on
previous page).
3. Re-position the loose burner parts.
4. Remove the screw on the left hand side of the grill burner and gently slide the
burner off the injector.
5. Using a 7mm socket, replace the grill injector as appropriate (see table on previous
page).
6. Re-assemble the burner.
7. Inside the main oven, remove the central screw securing the burner retainer. Slide the
retainer to the right slightly and lift away.
8. Lift the burner assembly and place on the floor of the oven to the right of the burner
opening.
9. Using a 7mm socket, replace the oven injector as appropriate (see table on previous
page).
10. Re-assemble the oven burner and retainer.
11. Carefully pull off the control knobs.
12. Using a narrow flat bladed screwdriver rotate the bypass screws fully clockwise. The
main oven and grill bypass screws are located on the body of the taps to the right of
the spindle. The hotplate tap bypass screws are located down the centre of the spindle.
13. Re-assemble the control panel parts.
14. Secure the self-adhesive LPG conversion label over the gas details on the data badge.
22
Installation Instructions