Filter
Top Products
Page 2 of 2 651418-XX-B (en)
PN 97999-8
PARTS LIST / 651418-XX-B
Item Description
(size)
(Qty) Part No. [Mtl]
1 Cap (1) 92990-1 [C]
2 Gasket (2) 91447 [D]
3 Spring (1) 90408 [SS]
4 Guide Button (1) 93949 [SS]
5 Ball
(13/16” o.d.)
(1) Y16-126 [SH]
6 Cartridge
(see table, page 1)
(1) 93945-XXX [SS]
7 Body (1) 92412-1 [C]
8 Filter Body (1) 92993 [C]
9 Pipe Plug
(3/8 - 18 N.P.T.)
(2) Y17-12-C [C]
10 Pipe Plug
(1 - 11-1/2 N.P.T.)
(1) Y17-15-C [C]
TYPICAL SYSTEM VIEW
Install the material lter either at the inlet of material handling
section or upstream from the other accessories (control handle,
etc.).
Refer to typical installation ( gure 2).
The lter unit was tested at the factory with a maximum work-
ing pressure of 6,000 p.s.i. (414 bar).
One Y17-15-C pipe plug is included with this unit to plug the
inlet port not being used. Two Y17-12-C pipe plugs are includ-
ed with this unit to plug the outlet ports not being used.
c
These system components are shown for installation purposes only
and must be purchased separately.
Filter
4-1/4" Pump
Material
Outlet Hose
Main air supply
F-R-L
Material
Inlet
Hose
Mounting
Bracket
Figure 2
1.
2.
3.
4
.
MATERIAL CODE
[C] = Carbon Steel
[D] = Acetal
[SH] = Hard Stainless Steel
[SS] = Stainless Steel
2
9
10
6
8
5
1
2
3
4
7
3
2
Apply Loctite® 277™ to threads.
Tighten to 30 - 40 ft lbs (40.7 - 54.2 Nm).
Figure 3
y
ARO® is a registered trademark of Ingersoll-Rand Company
y
y
Loctite® is a registered trademark of Henkel Loctite Corporation
y
y
277™ is a trademark of Henkel Loctite Corporation
y