Filter
Top Products
6. Take the Door Labyrinth Grommet and slide it over the portion of
the door gasket that is hanging over the seal lip.
7. Place the Splash Shield assembly inside the tub, centered on
the door. The taped edge goes against the top of the tub so that
the 1.25” lip hangs down. Position 1/2” from the backside of the
labyrinth.
AFTER MAINTENANCE ACTIONS
Run the machine through several cycles to ensure that
the gasket is sealing properly.
SPECIAL NOTES
Work performed on Jackson dishmachines by unautho
-
rized or unqualified personnel may void the warranty. Before begin
-
ning this or any other maintenance evolution on a unit under war
-
ranty, you should contact a certified Jackson technician or Jackson
Technical Service. You can find a list of qualified service agencies
in the back of you unit’s installation manual.
SPECIAL PARTS
None.
CONTACT INFORMATION
Jackson MSC Inc. provides technical support for all of the
dishmachines detailed in this manual. We strongly recommend that
you refer to this manual before making a call to our technical sup
-
port staff. Please have this manual with you when you call so that
our staff can refer you, if necessary, to the proper page. Technical
support is available from 8:00 a.m. to 5:00 p.m. (EST), Monday
through Friday. Technical support is not available on holidays.
Contact technical support toll free at 1-888-800-5672. Please
remember that technical support is available for service personnel
only.
www.jacksonmsc.com
JPX-300 Door Gasket Installation Kit
Revision A (12/13/05)
3
Positioning the Splash Shield inside the tub
Installing the door labyrinth grommet
Door Labyrinth Grommet
05700-003-13-77
Side profile showing placement of door labyrinth grommet
Splash shield assembly
Labyrinth
Placement of the splash shield assembly