Filter
Top Products
Tempstar/HH GPX Series Technical Manual 7610-002-57-32
Issued: 07-24-2006 Revised: N/A
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
OPERATION INSTRUCTIONS (CONTINUED)
13
OPERATIONAL INSPECTION: Based upon usage, the pan strainer may become clogged with soil and debris as the workday
progresses. Operators should regularly inspect the pan strainer to ensure it has not become clogged. If the strainer does, it will
reduce the washing capability of the machine. Instruct operators to clean out the pan strainer at regular intervals or as required
by work load.
SHUTDOWN AND CLEANING: At the end of the workday, close the doors. When the unit completes the cycle, turn the power
switch to the OFF position and open the doors. Remove and clean the pan strainer. Remove the drain stopper from the tub and
allow the tub to drain (NOTE: the wash tank water will be hot so caution is advised). Once the wash tub is drained, remove the
pump suction strainer. Remove soil and debris from the strainer and set to the side. Unscrew the wash and rinse arms from
their manifolds. Remove the endcaps and flush the arms with water. Use a brush to clean out the inside of the arms. If the noz-
zles appear to be clogged, use a toothpick to remove the obstruction. Wipe the inside of the unit out, removing all soil and
scraps. Reassemble the wash and rinse arms and replace them in the unit. The arms only need to be hand tight, do not use
tools to tighten them down. Reinstall the drain stopper
and strainers and close the doors.
WATER CONSUMPTION ISSUES AND EFFICIENCY: The Tempstar HH GPX provides you, the customer, with the ability to
control the hourly rack capacity of the machine. Extending the wash cycle to wash severely soiled ware, such as mixing bowls,
does not increase the machine’s water consumption. However, selecting a longer time cycle does lower the amount of dishes
the machine will be able to wash per hour. It is important for operators to select the correct wash cycle depending on the amount
of washing required. Not every rack of dishes requires the machine to be set on the longest wash cycle!
Using good prescrapping procedures and observing the results of individual racks of ware, operators will soon gain the expe-
rience and knowledge required to ensure that the Tempstar HH GPX operates at peak efficiency for your needs.
Water hardness and detergent usage will also effect the results of the Tempstar HH GPX. This manual provides a page enti-
tled “Detergent Control” for your reference. It is recommended that owners and operators take the time to carefully review this
section in order to ensure that everything is done to make sure the Tempstar HH GPX operates at peak performance!