Jenn-Air CCG2421 Cooktop User Manual


 
Whenthe control knobis turnedON,gas willflow intothe burner. The solidstate igniter
willclick as longas the knobis in the Lite position. (Note: All burner igniterswill spark
regardlessofwhichburneris beingoperatedwhen a knobisturnedto theIite position.)
A properlyadjustedburnerwith clean ports will light within a few seconds. On natural
gas, theflame will be bluewith a deeper blue inner core. There should be no trace of
yellowin theflame. A yellowflameindicatesan impropermixtureofair/gas. Thiswastes
fuel, sohavea servicemanadjustthemixtureifa yellowflameoccurs. On LPgas,some
yellowtipping is acceptable. This is normaland adjustment is not necessary.
Theinfinite surface controls provide flexibility in heat setting selection. (See page 7,)
Incaseof prolongedpowerfailure, youcanmanuallylightthe surfaceburnerby holding
alightedmatchneartheburnerportsandslowlyturningthe controlknobcounterclockwise
(after depressing)to the LJtesetting.
CAI,ITION: When lightingthesurface burner,besure all ofthe controlsare in theOFF
position. Strikethe matchfirst andhold it in positionbeforeturning the knobto the Lite
position.
Note: Becauseyouroverhead hoodfanis electricitwill notwork duringa powerfailure
so smokeand condensationcan gather.
COUNTERCLO£;KWlSE
t TO,NCREASE_LAME
TheLo setting shouldproduce a stableflame _ _1SLzE
when turning the knob from Hi to Io. The CLOCKW,SE.IIIIA
TO REDUCE
flame shouldextendto the outer edge of the FLAMESIZE
lipoftheburnercaponthe Lo settingandmust
be stable on all ports on Lo setting.
VALVW
To adjust" Operateburner on Hi for about 5 STEM , ,
minutes to preheat burner cap. Turn knob
back to Lo; removeknob, and insert a small
screwdriverintothe center of the valve stem.
Adjustflamesize byturningadjustmentscrew
in eitherdirectionwhile holdingthevalvestem
securely.
Flamemustbe of sufficientsize tobe stable on all burnerports. If flame adjustmentis
needed,adjust ONLY on the Lo setting. Never adjustflame size on a higher setting.
Note: All gasadjustments shouldbe done by a qualified serviceronly.
6