Filter
Top Products
Storage an d Maintenance ,J
Vacations cartridge. A new cartridge can be installed when the
If you will be gone for a month or less, leave the controls refrigerator is put back in service,
at the usual settings, e) clean and dry the refrigerator thoroughly,
During longer absences: f) leave the doors open to prevent odors.
a) remove all food,
b) shut off the ice maker (if installed) and the valve where Moving
you tapped into the water line to supply the refrigerator,
When moving, follow steps a-f under Vacations. In addl-
e) disconnect the refrigerator from the electrical outlet, tion, remove and carefully pack any items that are easily
d) remove the filter cartridge (certain models) and install removable. Ship the refrigerator in an upright position with
the filter bypass (see page 14-15). Dispose of the used the doors taped shut.
Replacing a Light Bulb
_ CAUTION: Disconnect the power cord before replacing light bulb(s). Wear gloves as
protection against possible broken glass.
Always use a standard 40 or 60 watt appliance bulb when replacing a fresh food or freez-
er compartment bulb.
Refrigerator Freezer
There are two light bulbs located at the top of the refriger- The freezer light is located on the back wall of the freezer
ator compartment, on the underside of the Twin Fresh TM compartment.
control housing. To replace:
To replace a lightbulb(s), remove the control cover from • unhook the tabs on the top of the light shield by press-
the control housing: ing in with the thumb on the center top of the light shield
• grasp the control cover at the two rear "finger tabs".
These are located at the upper rear of the fresh food • pivot the shield down
compartment, behind the light shields. • unscrew the bulb when cool and replace it with a stan-
dard 40-watt appliance bulb
• pull down slightly to clear the retainer tabs and slide the
cover forward until it is free. • replace the bulb cover by pivoting it back into place and
• replace the bulb(s) with a 60-watt, standard base appli- snapping the tabs into the appropriate slots.
ance bulb(s).
• After replacing the bulb(s), align the control cover on to Dispenser Light (dispenser models only)
the ribs on the control housing and slide it straight back To replace:
until it snaps onto the retainer tabs.
• Locate the lightbulb in the dispenser area to the left of
On certain models, there is an additional light located
the actuator
behind the top drawer. To replace:
• Unscrew the used bulb and remove.
• remove the top drawer and cover as explained on page 10.
• carefully reach into the bulb cover and unscrew the • Replace the bulb, using a 120V, 7-watt bulb.
lightbulb.
• replace the bulb with a 60-watt appliance bulb.