Filter
Top Products
Controls At A Glance (continued)
Delay/Resume Control Lock Option
The Delay/Resume option can be used to automatically The control touchpads can be locked to prevent unwanted
start the cycle at a later time, such as during off-peak hours use. If this feature is activated between cycles, the dish-
for reduced energy usage or to reduce daytime heat washer cannot be operated until the controls are unlocked.
If desired, the controls can be locked after a cycle or delay
buildup in the home. has started.
To Set Up a Delay: Note: This option does not lock the door, only the dish-
Press and hold the Delay/Resume pad until the washer controls.
desired amount of delay time is selected. The delay
time will begin counting down when the pad is Setting the Control Lock:
released. 4, Press the _ pad for three seconds.
Select the appropriate cycle and options for the load. 4' An indicator light will illuminate when the controls
The Delay/Resume indicator light will remain lit are locked.
until the delay time has counted down. To Cancel:
The cycle will automatically start as soon as the 4, Press the_ pad for three seconds.
delay time expires.
The indicator light will go off.
I
Note: If Delay/Resume is chosen without selecting a cycle ]
and/or options,the dishwasber willselect the lastcycle used. Note: If a cycle or option pad is pressed after the con-
(It willnot remember the Rinse Only cycle.) times,trois have been locked, the indicator light will flash five
To Cancel a Delay:
Wait at least 2 seconds, then press the Delay/Resume pad
again. The indicator light will go out and the cycle will
start or resume immediately.
Operating Tips
Starting The Dishwasher Adding a Forgotten Item
After loading the dishwasher and adding detergent, For best cleaning, the forgotten item should be added early
close the dishwasher by pressing the door until the in the cycle.
latch clicks. _ Press the Delay/Resume pad or unlatch the door.
To start the dishwasher, firmly press the desired
•' Wait for the water circulation to stop.
cycle and options pads. After a pause, the fill will
begin. To prevent unplanned cycle or option • Open the door and add the item.
changes, these selections are "locked in" after 1
Close and latch the door.
minute.
• If Delay/Resume was pushed, push it again to
The indicator lights for the selected cycle and
options will glow. restart the dishwasher.
After five seconds, the cycle resumes automatically
To cancel an option, press the pad again. To cancel a
at the point of interruption.
cycle, press the Drain/Off pad.
Note: Extended interruption of the wash cycle is not
recommended.