Filter
Top Products
24
OVEN RACKS
Cleaning Method:
■ Self-Cleaning cycle:
See “Self-Cleaning Cycle” first. Remove racks or they will
discolor and become harder to slide. If this happens, a light
coating of vegetable oil applied to the rack guides will help
them slide.
■ Steel-wool pad
DOWNDRAFT VENTILATION SYSTEM
Vent Grill
Cleaning Method:
■ Lift the vent grill off the cooktop.
■ Wipe clean or wash in sink:
Nonabrasive plastic scrubbing pad and mildly abrasive
cleanser
■ Dishwasher:
Use mild detergent.
Filter
The filter is a permanent type and should be cleaned when soiled.
Cleaning Method:
■ Turn off the downdraft ventilation system before removing the
filter.
■ Remove vent grill then lift the filter out of the vent chamber.
■ Clean the filter in the sink with warm water and detergent or in
the dishwasher.
■ Replace the filter.
The filter should always be placed at an angle. As you face
the front of the range, the top of the filter should rest against
the left side of the vent opening. The bottom of the filter
should rest against the right side of the vent chamber at the
bottom.
If the filter is flat against the fan wall, ventilation effectiveness
will be reduced.
Ventilation Chamber
The ventilation chamber, which houses the filter, should be
cleaned in the event of spills or when it becomes coated with a
film of grease.
Cleaning Method:
■ Mild household detergent or cleanser and paper towel, damp
cloth or sponge:
Apply detergent or cleanser to paper towel, damp cloth or
sponge, not directly to the ventilation chamber.
Oven Lights
The oven uses a 120-volt, 20-watt maximum halogen bulb. See
the “Assistance or Service” section to order. Ask for Part Number
74004458.
To Replace Oven Light:
Before replacing, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Use fingertips to grasp edge of bulb cover. Pull out and
remove.
3. Remove bulb from socket by pulling straight out of the
ceramic base.
4. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage or decreasing the life of the new bulb,
do not touch bulb with bare fingers.
5. Replace bulb cover by snapping back into place.
6. Plug in range or reconnect power.
A. Vent grill
A