Filter
Top Products
6
USING YOUR COOKTOP
Cooktop at a Glance
MODEL JGC8536
1. Left rear surface burner (9,200 BTUs).
2. Left front surface burner (5,000 BTUs on Hi, 650 BTUs on
Lo).
3. Center surface burner (15,000 BTUs).
4. Right front surface burner (12,500 BTUs).
5. Right rear surface burner (5,000 BTUs on Hi, 650 BTUs on
Lo).
MODEL JGC8430B
1 2 3 4 5
1. Left rear surface burner (10,500 BTUs).
2. Left front surface burner (5,000 BTUs on Hi, 650 BTUs on
Lo).
3. Right front surface burner (15,000 BTUs).
4. Right rear surface burner (9,200 BTUs).
To prevent the cooktop from discoloring or
staining:
• Clean cooktop after each use.
• Wipe acidic or sugary spills as soon as the cooktop has
cooled as these spills may discolor the surface.
Sealed Burners
The sealed burners are secured to the cooktop and are not
designed to be removed. Since the burners are sealed into
the cooktop, boilovers or spills will not seep underneath the
cooktop.
However, the burners should be cleaned after each use. The
head portion of the burner is easily removed for cleaning.
(See page 7 for cleaning directions.)
Burner caps must be correctly placed on the burner base for
proper operation of the burner.
High Performance Burner*
There is one high speed burner on your cooktop, located in
the center or right front position. This burner offers higher
speed cooking that can be used to quickly bring water to a
boil and for large-quantity cooking.
Simmer Burners*
These burners are located in the left front position and/or the
right rear position. The simmer burner offers a lower BTU
flame for delicate sauces or melting chocolate.
* BTU ratings will vary when using LP gas.
Burner Grates
The grates must be properly positioned before cooking.
Improper installation of the grates may result in chipping of
the cooktop. To ensure proper positioning, align bumpers on
grate bottom with the indentations in the cooktop.
Do not operate the burners without a pan on the grate.
The grate’s porcelain finish may chip without a pan to
absorb the heat from the burner flame.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor, due to the high temperatures
of the gas flame.
Notes :
•A properly adjusted burner with clean ports will light
within a few seconds. If using natural gas, the flame will
be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas
mixture may be incorrect. Contact a service technician
to adjust. (Adjustments are not covered by the war-
ranty.)
With LP gas, some yellow tips on the flames are accept-
able. This is normal and adjustment is not necessary.
• With some types of gas, you may hear a “popping”
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
• To improve cooking efficiency and to prevent possible
damage to the cooktop or pan, the flame must be
adjusted so it does not extend beyond the edge of the
pan.