Jenn-Air JJW8627 Oven User Manual


 
resistance of the sensor increases. The
resistance of the sensor at 350°F is approxi-
mately 1654 ohms. The electronic control
monitors the resistance value of the sensor
and cycles the oven heating elements off.
As the temperature in the oven decreases,
the resistance of the sensor decreases. At a
predetermined temperature setting, the
electronic control will initiate another heat-
ing cycle in the oven elements. See oven
sensor chart at right for resistance values.
OVEN SENSOR
Sensor Type: Calibration:
RTD 1000 ohm platinum 1654 ohms (350°E)
OVEN SENSOR RESISTANCE VS. TEMP. TABLE
Degrees E Resistance
100 1143 ohms
200 1350 ohms
300 1553 ohms
350 1654 ohms
400 1753 ohms
500 1949 ohms
600 2142 ohms
700 2331 ohms
800 "2516 ohms
900 2697 ohms
1000 2874 ohms
FAULT CODES
There are built-in fault codes to assist the technician in diagnosis of the control system. Any
time the control senses an error in the system, the control will beep at s 1 second interval
until the ON/OFF key is pressed.
_u_
CODES
F1
F3
F9
PROBLEM
Oven Temperature
Shorted Key, Keyboard
Disconnected
Sensor Failure or Sensor
Circuit Failure
Door Code
COMPONENTS TO CHECK
Ohm Test Sensor. Check connection at Sensor Wire
Harness
Check control. If keyboard is not disconnected (F1-4) or
key is not shorted (F1-3), replace control.
Ohm sensor. See chart,
Check Latch Assembly
For Models:
WW27110, WW30110, WM27160 (Oven Sensor Chart: Please refer to chart on 1-3)
16009721 COMPONENT DESCRIPTION 1-2
O199g Maytag Appliances Sales Company