Filter
Top Products
TOCORRECTTHIS TOCORRECTTHIS
CONDITION,RAISE CONDITION,RAISE
RIGHTCORNERAND LEFTCORNERAND
/ORLOWERLEFT /ORLOWERRIGHT
CORNERUNTIL CORNERUNTIL
DOORSALIGN DOORSALIGN
ACROSSTOPOF ACROSSTOPOF
CABINET. CABINET.
Electrical Connection
and Grounding POWERSUPPLYCORD
WITH. 3-PRONG / i \
This appliance is designed to operate on a GROUNDINGPLUG"
nominal 115volt, 15amp, 60 cycle line. There \| II,)
should be a separate, grounded circuit, serv-
ing this appliance only. DO NOT use an ex-
tension cord. / " ",
This appliance is equipped with a three- \11 II)
pronged grounding plug for your protection
against possible electrical shock hazards. It
GROUNDING TYP
must be plugged into a grounding receptacle. WALLRECEPTACLE
Where a standard two prong wall receptacle *LOCATIONOFPRONGSONPOWERCORD
iSencountered, it isthe personal responsibil- PLUGMAYBEDIFFERENTONYOURMODELTHAN SHOWN HERE.
ity and obligation of the customer to have it
replaced with a properly grounded three-prong wall receptacle. DO NOT,under any cir-
cumstances, cut or remove the third (ground) prong from the power cord.
DO NOT use an adapter plug.
]¥im Kits (Models JRS226, JRSD226 Only)
Your refrigerator has been designed so that black door panels, custom cabinet panels
(up to 1/4"thick) or any custom panel (up to .060" thick) can be easily installed. Toinstall
either custom cut black door panels or decorator trim kit for custom cabinet panels, ord-
er the appropriate kit listed below.The kit contains the installation instructions. To install
a custom panel for example formica, stainless steel or others (up to .060" thick), refer
to the enclosed cutout and installation sheet.
Note: Read all cutout and installation instructions before cutting custom panels.
For JRS226 you will want to order:
Model BDS22-02 - Black door panel kit.
Model DTS22-02- Decorator trim kit. (To be used with custom cabinet panels up to 1/4"
thick.)
For JRSD226 you will want to order:
Model BDS22D-02 - Black door panel kit.
Model DTSD22-02-Decoratortrim kit.(To be used with custom cabinet panels up to 1/4"
thick.)