Filter
Top Products
INSTALLATION
6
MOUNTING THE RANGEHOOD
1. This range hood is mounted under a
kitchen cabinet unit.
2. Select preferred duct location on rear or
top of unit. For ductless conversion, no
ducting is required.
3. Begin installation by temporarily removing
the diffuser and filter panels.
4. Temporarily position the range hood in
the desired mounting location.
Measure and mark the mounting holes,
duct and electrical access locations with
a pencil.
5. Drill/cut out the required openings for
duct and electrical access; make sure the
duct opening is large enough to apply
duct tape.
6. Fasten mounting screws onto
cabinet as marked, do not tighten,
leaving half length of screws exposed.
7. Install electrical.
8. Hang hood onto screws through key
holes, and tighten.
9. Install duct work and duct-tape.
10. Reinstall the difuser panels.
11. Power up hood and check for leaks
around duct-tape.
duct/silver
tape