Filter
Top Products
5
COOKTOP USE
Cooktop Controls
Electric igniters automatically light the surface burners when
control knobs are turned to HIGH and will automatically reignite if
the flame is extinguished. All igniters will spark when lighting;
however, only the selected burner will ignite.
If a crossdraft is present, the flame may be affected and some
sparking may occur. This is normal.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner using empty cookware or without
cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to HIGH.
2. Turn knob to anywhere between HIGH and LOW. Use the
following chart as a guide when setting heat levels.
Power failure
In case of prolonged power failure, the surface burners can be lit
manually. Hold a lit match near a burner and turn knob
counterclockwise to HIGH. After burner lights, turn knob to
setting. The vent fan will not work.
NOTE: The downdraft vent will not operate during a power failure.
Flame-Sensing™ ReIgnition
Your cooktop has sealed gas burners with Flame-Sensing™
ReIgnition. If any burner flame should go out, the system will
automatically spark to reignite the burner (all igniters will spark
when any flame is extinguished; however, only the selected burner
will reignite).
If intermittent sparking occurs, increase flame (rotate knob
clockwise) until clicking (spark) sound ceases.
Smart Port Burner System
This cooktop is equipped with a Smart Port Burner System. The
Smart Port Burner System produces a small flame directly under
each grate finger and a larger flame between each grate finger.
The visual difference between the ports will be noticeable when
the burner is used or when adjustments are made to the flame
length.
Sealed Surface Burners
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap and head in place when
using a surface burner. A clean burner cap and head will help
prevent poor ignition and uneven flames. Always clean the burner
cap and head after a spillover and routinely remove and clean the
caps according to the “General Cleaning” section.
SETTING RECOMMENDED USE
HIGH
■ Start food cooking.
■ Bring liquid to a boil.
■ Hold a rapid boil.
■ Quickly brown or sear food.
■ To fry chicken.
Medium
Between HIGH and
LOW
■ Maintain a slow boil.
■ Fry or sauté foods.
■ Cook soups, sauces and gravies.
■ Stew or steam food.
LOW
■ Simmer.
■ Keep food warm.
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
A.Burner cap
B.Burner ports
C.Burner base
D.Gas tube opening
E.Igniter head
A
B
C
D
E