Filter
Top Products
12
Install Vent Covers
NOTE: This hood can be installed without the chimney covers
when venting directly out the back or when using the recirculation
kit with the top grille cap. See the “For non-vented (recirculating)
installations without vent only:” section
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with
two 4 x 8 mm screws.
NOTE: For vented installations the upper vent cover may be
reversed to hide slots.
Secure the bottom of the duct with 2 - 4 x 8 mm screws.
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the “Range
Hood Care” section.
2. Install metal filters. See the “Range Hood Care” section.
3. Check the operation of the range hood blower and light. See
the “Range Hood Use” section.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located at the bottom right hand
side of the canopy.
Range Hood Controls
Operating the light
The Light On/Off button controls both lights. Press once for On
and again for Off.
A. Upper vent cover
B. Lower vent cover
C. 4 x 8 mm screws
D. Bracket
A
B
C
D
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Canopy
D. Control panel
E. Grease filter
F. Grease filter release handle
G. Lamp housings
A. Light on/off
B. Fan off
C. Fan speed minimum button
D. Fan speed medium button
E. Fan speed maximum button
A
B
C
E
F
G
D
Light
On/Off
Fan
Off
1
2
3
A
B
C
D
E