Filter
Top Products
Safety instructions
Warning! You must read these!
Make sure that the appliance is not
damaged because of transportation.
Do not connect a damaged appliance.
If it is necessary, speak to the supplier.
Only an authorised service technician
can install, connect or repair this
appliance. Use only original spare
parts.
Only use built-in appliances after you
assemble the appliance into correct
built-in units and work surfaces that
align to the standards.
Do not change the specifications or
modify this product. Risk of injury and
damage to the appliance.
Fully obey the laws, ordinances,
directives and standards in force in the
country where you use the appliance
(safety regulations, recycling
regulations, electrical safety rules etc.)!
Keep the minimum distances to other
appliances and units!
Install anti-shock protection, for
example install the drawers only with
a protective floor directly below the
appliance!
Protect the cut surfaces of the
worktop against moisture with a
correct sealant!
Seal the appliance to the work top with
no space left with a correct sealant!
Protect the bottom of the appliance
from steam and moisture, e.g. from a
dishwasher or oven!
Do not install the appliance adjacent to
doors and below windows! If not, hot
cookware can be hit off the hob when
you open doors or windows.
Warning! Risk of injury from
electrical current. Carefully obey the
instructions for electrical connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Install correctly to give anti-shock
protection.
• Loose and incorrect plug and socket
connections can make the terminal become
too hot.
• A qualified electrician must install the
clamping connections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-
F Tmax 90°C (or higher) for a single-phase
or two-phase connection.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C; or
higher). Speak your local Service Force
Centre.
The appliance must have the electrical
installation which lets you disconnect the
appliance from the mains at all poles with a
contact opening width of minimum 3 mm.
You must have correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.
12