John Lewis JLBIFF 1801 Refrigerator User Manual


 
Defrosting
Refrigerator
The refrigerator automatically defrosts every time the
compressor stops.The water is discharged, via the pipe, into
a tray located at the back of the appliance above the
compressor, where it evaporates.
Important
To avoid defrost water overflowing into the fridge,
periodically clean the water discharge hole in the centre of
the V shaped drip collector at the back of the refrigerator
compartment behind the fruit and vegetable drawer. Use the
defrost cleaner provided which you will find already
inserted into the discharge hole.
Remember to wash the defrost cleaner in hot soapy water
at regular intervals. Dry throughly before replacing.
Freezer
Your appliance is frost free, which means there is no need
to manually defrost your appliance as this will be carried out
automatically.
D037
Before any maintenance or cleaning work is carried
out, DISCONNECT the appliance from the
ELECTRICITY supply.
Internal cleaning
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).
Rinse and dry thoroughly.
NEVER USE DETERGENTS,
ABRASIVE POWDERS, HIGHLY
PERFUMED CLEANING PRODUCTS
OR WAX POLISHES,TO CLEAN THE
INTERIOR AS THESE WILL DAMAGE
THE SURFACE AND LEAVE A
STRONG ODOUR.
When the appliance is not in
use
When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all
foods and clean the appliance, leaving the doors ajar
to prevent unpleasant smells.
Changing the light bulb
Should the interior light fail to work, first switch off
the appliance and disconnect from the electricity
supply, then replace the bulb as follows;
External cleaning
Once or twice a year dust the condenser (black
grill) and the compressor at the back of the
appliance, with a brush or vacuum cleaner, see
figure, as an accumulation of dust will affect the
performance of the appliance and cause excessive
electricity consumption.
PR259
press on the rear hook and at the same time slide the cover in
the direction indicated by the arrow.
Unscrew the bulb and replace it with one of the same
power (the maximum power is shown on the light diffuser)
available from your nearest Service Force Centre.
Replace the light cover by sliding it into its original position.
Maintenance and Cleaning
17