John Lewis JLBIHD603 Ventilation Hood User Manual


 
5
Please ensure that when the appliance is installed
it is easily accessible to an engineer in the event
of a breakdown.
All installations must comply with the local
authorities requirements for the discharge of
exhaust air.
Incorrect installation may affect the safety of
this cooker hood.
Installation Requirements
Before installation check the wall to which
the cooker hood is to be fitted for electric
cables, water pipes or gas.
The chimney hood must be installed accord-
ing to the instructions suppliers below and
by qualified and competent personnel to the
relevant National Standards.
This cooker hood is designed to be fixed to any vertical
surface over a cooking area, and can be used in the extrac-
tion (ducted to the outside) or recirculation mode.
The installation work must be undertaken by a qualified
and competent person.
The manufacturer disclaims any responsibility for dam-
age due to incorrect installation of the cooker hood or
if the hood is not installed in compliance with relevant
regulations controlling this type of installation.
Unpacking
Before unpacking the cooker hood position the carton
with the arrows pointing upwards as illustrated on the
carton.
The cooker hood is made up of the following compo-
nents:
Ref Qty Product Components
1 1 Canopy complete with: Controls, Light-
ing, Fan Assembly, Grease Filter, Charcoal
Filter.
2 1 Telescopic Chimney comprising:
2.1 1 Upper Chimney Stack
2.2 1 Lower Chimney Stack
8a 1 Right-Hand Recirculation grille
8b 1 Left-Hand Recirculation grille
9 1 ø150-120 Ducting Spigot
10 1 ø120-125 Ducting flange
14 1 Ducting Extension Pipe
14.1 2 Recirculation Outlet Extentions
15 1 Recirculation Outlet Adapter
Ref Qty Installation Components
7.2.1 2 Upper chimney wall fixing brackets
12c 6 Chimney fixing screws
Ref Qty Documentation
1 Instruction booklet
2.1
2.2
2
12c
7.2.1
1
8a
9
10
8b
14
14.1
15
Installation