Filter
Top Products
7
The appliance must always be transported in the
vertical position as indicated on the outside of the
packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
To ensure the coolant gases settle.
Unpack the Fridge Freezer and check for any possible
damage. If the appliance is damaged please report this to the
John Lewis branch from which you purchased; in this case
please retain the packaging. Report possible damages
immediately to the place you bought it. In that case retain
packaging.
Cleaning
Remove all adhesive tape and ties, which ensure the internal
fittings do not move during transportation.
Wash the inside of the appliance using lukewarm water and
mild detergent; using a soft cloth.
Further cleaning advice is given on page 18. wipe out the
inside of the appliance.
Positioning
The appliance should be located in a well ventilated, dry
room.To ensure correct operation the appliance should:
Not be exposed to direct sunlight.
Not be installed next to radiators, cookers or other
sources of heat.
Only be installed in a location where the ambient
temperature corresponds to the climate classification for
which the appliance is designed.
Climate Classification
The climate classification can be found on the rating plate;
which is located on the bottom left hand side of the fridge
compartment, see page 5' .
The table shows the correct operating ambient temperature
for each climate class.
Class of climate Ambient temperature
SN +10…+32°C
N +16…+32°C
ST +18…+38°C
If the temperature rises above or falls below the stated
ambient temperature for the climate class, the operation of
the appliance may be affected.
Ventilation
You should ensure that air could circulate freely around the
back and top of the cabinet. In the Instruction manual bag
there are two spacers which must be fitted to the top rear
corners. This will ensure a gap is maintained between the
Fridge Freezer and the wall.
Loosen the screws and insert the spacer under the screw
head, then re-tighten the screws.
Levelling
When placing the appliance ensure that it stands level, to
prevent
vibration, excessive noise and to ensure the doors shut
correctly.
Level the appliance by turning the 2 adjustable feet at the
front of the Fridge Freezer.
Unpacking
When placing the refrigerator keep minimal
distances recommended in figure.
A: placing it under a wall-cupboard
B: placing it freely