Filter
Top Products
8
Should the location or handling demand it, door-opening
direction can be refitted from right-handed to left-handed.
Appliances on the market are right-handed.
Following operations are to be done on the basis of figures
and explanations:
1. To perform the operations listed below it is
recommended to ask another person for help while
performing the operations.
2. Disconnect the appliance from the electricity supply.
3. Open the doors and dismount the double door hinge
(a,b) by removing the screws (2 pieces) (c). (fig. 2)
4. Take off the double door hinge (a,b,c) by gradually
removing it from the cabinet, slightly tilting both doors.
Do not forget to remove the plastic spacer (b) under
the hinge. (fig. 2)
5. Take off the refrigerator door by pulling it slightly
downwards.
6. Take off the freezer door by pulling it slightly upwards.
7. Unscrew the top door hinge pin (d) of the refrigerator
then screw it back on the other side. (fig. 1)
8. Remove the insert of the plinth (e) by a screwdriver.
(fig. 3)
9. Unmount the lower hinge pin (f) and its washer (h) and
mount them on the other side. (fig. 3)
10. Replace the insert of the plinth (e) on the other side.
11. Remove the blanking pins (3 pieces) (n,k) of the double
door holder on the left side and put them to the other
side. (fig. 2)
12. Fit the pin of the double door hinge (m) into the left drill
of the freezer door. (fig. 2)
13. Fit the freezer door to the lower door hinge pin (f).
(fig. 3)
14. Fit the refrigerator door to the upper door hinge pin (d)
then slightly tilting both doors fit the pin of the double
door hinge (m) into the left drill of the refrigerator
door.
15. Opening both doors fix the double door hinge onto the
left side using the screws (2 pieces) (c). Do not forget
to replace the plastic spacer (b) under the hinge. Be
careful that the door edges are parallel with the edge of
the top panel.
16. Put over the handles (r) on the other side and put the
plastic blanking pins (p) supplied in the plastic bag of this
instruction book into the holes set free. (fig. 4)
17. Put the appliance to its place, set it level, and apply to
voltage it.
In case you do not want to perform the procedures above,
call your local Service Force.Technicians will accomplish the
refitting expertly for charge.
fig. 1.
fig . 2.
fig. 3.
fig. 4.
Change of door opening direction