John Lewis JLFZW1810 Freezer User Manual


 
18
Door reversibility
Before carrying out any operations,remove the plug
from the power socket.
We suggest that this be done with another person who
will keep a firm hold on the doors of the appliance
during the operations.
Open the door with the appliance in the upright
position.Unscrew the screws and remove the upper
door plastic trim.
Remove the little plastic cover from the door plastic
trim and refit on the opposite side (d).
Lay the appliance onto its back side.
Remove the screw of the hinge cover plug (a).
Unscrew the upper hinge and remove it (b).
Unscrew the screw and remove the door stopper (c).
Remove the door.
Remove using a tool the cover (e) unscrew the
lower hinge pivot (f) and place it on the opposite
side.
Reinsert the cover (e) on the opposite side.
Reinsert the door .
Pay attention that the front board of the doors are parallel
to the front board of the top.
Fix the door stopper on the opposite side.
Position and fix the upper hinge (that can be found in the
instruction for use bag) on the opposite side .
Fix the screw of the new cover hinge (that can be found in the
instruction for use bag).
Lift up the appliance to vertical position.
Open the door and reposition the upper door plastic trim with
screws.
Fix the handle on the opposite side,insert the plastic plugs into
the holes left open that can be found in the instruction for use
bag.
Reposition,level the appliance, wait for at least two
hours and then connect it to the power socket.
In case you do not want to carry out the above operations,
contact the nearest After Sales Service Force.The After Sales
Service specialist will carry out the reversibility of the
doors at your cost.
Warning
After having reversed the opening direction of the
doors check that all the screws are properly
tightened and that the magnetic seal adheres to the
cabinet.
If the ambient temperature is cold (i.e.in Winter),
the gasket may not fit perfectly to the cabinet.In
that case, wait for the natural fitting of the gasket
or accelerate this process by heating up the part
involved with a normal hairdryer.Lay the appliance
onto its back side.
a
b
c