Filter
Top Products
8
Push button
A. Mains indicator light (green)
B. Fridge compartment button ON/OFF
C. Temperature setting button (+) (for warmer
temperatures)
D. Temperature display
The control panel refrigerator
˚C
OffOn/
Quick
cool
Switching off
The appliance is switched off by holding in button (B)
for more than 1 second. After this, a countdown on
the temperature display from -3 -2 -1 will be shown.
When the appliance is switched off, the display (D)
also goes off.
Temperature setting buttons
The temperature is adjusted using the “C“ (+) and
“E“ (-) buttons.These buttons are connected to the
temperature display.
The temperature display is switched over from the
display of the ACTUAL temperature (Temperature
display is illuminated) to the display of the DESIRED
temperature (Temperature display flashes) by
pressing one of the two buttons,“C“ (+) or “E“ (-).
Each time one of the two buttons is pressed again
the DESIRED temperature is adjusted by 1 °C.The
DESIRED temperature must be reached within 24
hours.
If neither button is pressed, the temperature display
automatically switches back after a short period
(approx. 5 sec.) to the display of the ACTUAL
temperature.
DESIRED temperature means:
The temperature that has been selected for inside
the fridge.The DESIRED temperature is indicated by
flashing numbers.
ACTUAL temperature means:
The temperature display indicates the current
temperature inside the fridge. The ACTUAL
temperature is indicated with illuminated numbers.
E. Temperature setting button (-) (for colder
temperatures)
F . Quick cool function "on" indicator light (yellow)
G. Quick cool button
When the fridge is first
installed
Warning
Allow the appliance to stand for 2 hours after
installation.
Insert the plugs into the wall socket.
If the display is OFF press the ON/OFF button.
The green mains indicator light illuminates.
The appliance starts.
Press either the “C“ (+) or “E“ (-) button. The
temperature display switches over and the DESIRED
temperature currently set flashes on the
temperature display.
Set the required temperature by pressing the “C“ (+)
or “E“ (-) buttons (see section "Temperature setting
buttons"). The temperature display will immediately
show the changed setting. Each time a button is
pressed the temperature is adjusted by 1 °C.
From a food safety point of view +5 °C should be
considered sufficiently cold for storing food in the
fridge.
Once the required temperature has been set, after a
short period (approx. 5 sec.) the temperature
display will change and again indicate the current
ACTUAL temperature inside the fridge. The display
will change from flashing to continuous illumination.
Information! When the setting is changed, the
compressor does not start immediately if automatic
defrosting is currently taking place. As the storage
temperature within the fridge is reached quickly you
can store food immediately after switching on.