Filter
Top Products
.Subject to change without notice. Published in U.S.A 689282-UUM-A-0812
Copyright © 2012 by Johnson Controls, Inc. All rights reserved. Supersedes: Nothing
York International Corp.
5005 York Drive
Norman, OK 73069
NON-PROGRAMMABLE MODE OPERATION
Temperature Setpoint
Press Zone Temperature Adjustment Arrows either up or
down until the desired temperature setpoint is shown.
Zone Fan Setting
In non-programmable mode, the fan setting of your Zone Dis-
play defaults to fan Auto Mode. In Auto Mode the fan runs only
when the system is actively heating or cooling using the indoor
and/or outdoor equipment. You can also change the Fan to
Manual Mode at any time using the Fan button. In Manual
Mode you can specify the amount of time the fan should run
each hour. The time is specified in minutes with selection
choices of 15, 30, 45, and 60 minutes per hour. Selecting 60
minutes will cause the fan to run continually. The fan will run at
the speed specified at the Master Touch Screen control.
The fan setting made at the Zone Display applies only to this
sensor’s zone.
PROGRAMMABLE MODE OPERATION
In programmable mode, the Master Touch Screen control sets
your Zone Display temperature setpoint based on the specified
schedule. However, you can override the scheduled tempera-
ture setpoint at any time using the Zone Temperature Adjust-
ment Arrows.
Temperature Override
Press the Zone Temperature Adjustment Arrows either up or
down until the desired override temperature setpoint is shown.
The control displays the Hold icon to indicate a temperature
hold is active.
The Temperature Override Hold can be cancelled by pressing
the Cancel Hold button.
Zone Fan Setting
In programmable mode, the fan setting of your Zone Sensor
defaults to fan Schedule Mode. In Schedule Mode the fan runs
according to the schedule specified in the Master Touch Screen
control. You can also change the Fan to Manual Mode at any
time using the Fan button. The operation is the same as
described above for non-programmable mode.
OTHER FEATURES
Outdoor Temperature Display
The Zone Display will display the outdoor temperature if you
press the Outdoor button. The units of the displayed tempera-
ture are based on the Zoning system settings made at the Mas-
ter Touch Screen control.
Zone Number Display
The Zone Display will display its zone number if you press and
hold the Cancel Hold button for 5 seconds.
The date and time on the Zone Display are set and updated
by the Master Touch Screen. The date and time do not have
to be set at the Zone Display.
NOTICE