Jura Capresso E30 Coffeemaker User Manual


 
13
Switch on machine by pressing button.
Push button for about 3 seconds. Warning lamps ,
(if necessary) , light up.
Fill water tank.
Empty drip tray and grounds container and replace them. War-
ning lamps (if necessary) go out.
Place a container under the coffee-spout (9).
Put a Jura cleaning tablet (Fig. 9) into the powder funnel (10).
Press selector button . The warning lamp goes out.
Warning lamp flashes.
The flashing of warning lamp indicates that the cleaning
process is activated.
If warning lamp lights up, empty drip tray (if necessary),
wait about 10 seconds before replacing it. Warning lamp
goes out.
Replace the container under the coffee-spout (9) and press button
.
The cleaning process is continued.
If warning lamp lights up again, empty drip tray (if neces-
sary), wait about 10 seconds before replacing it. Warning lamp
goes out.
Replace the container under the coffee-spout (9) and press button
.
The cleaning process is continued. At the end of it, warning lamp
lights up.
Empty drip tray and grounds container and replace them.
Warning lamp lights up.
Replace container under the coffee spout (9) and press button
. The machine rinses and warning lamp lights up.
Tip: Clean powder funnel with a bottle-brush.
13. Decalcifying
Your machine has an integrated decalcifying program. If a Claris fil-
ter cartridge is used there is no need for decalcifying your machine.
Please use Jura decalcifying tablets only. These are available from
your Jura dealer
Note: If the machine needs decalcifying warning lamp
lights up. You can still draw off coffee and hot-water/steam
and run the decalcifying program later.
Important: Run the decalcifying program only after the ma-
chine has been switched off for at least 2 hours and has
cooled down completely. The decalcifying program is started
with the machine switched off. The running decalcifying
program must not be interrupted.
Switch off machine by pressing button and let the machine
cool down for 2 hours.
Then remove water tank.
Press button for about 3 seconds. Warning lamps , ,
light up.
Pour 0,5 litres of water into a container and completely dissolve
the contents of a blister pack (2 tablets). Then fill the mixture in-
to the water tank.
Empty drip tray and replace it. Warning lamps , , ,
flash and warning lamp lights up.
Place a sufficiently big container under the pivoting nozzle (13).
Turn selector switch for hot-water/steam (12) to position .
E